Accucold AWC2PB handleiding
Handleiding
Je bekijkt pagina 7 van 16
6
• Leave at least 2 inches (50mm) of space between the back of the unit and the wall behind, which
allows for proper air circulation.
• Plug the unit into a 120V AC 60Hz electrical source. The fuse or circuit breaker should be rated for
15 amperes. The unit is designed to be used in a stable environment where the ideal ambient
temperature is 72°F (23.89°C) or less. Extremely warm or cold ambient temperatures may cause
the appliance to perform improperly.
• Avoid placing the blanket warmer in moist areas. This appliance is equipped with a three-prong
plug and is grounded to eliminate electrical hazards. In order to make it effective, the unit must
be plugged into a grounded electrical outlet. A short power-supply cord (or short detachable
power-supply cord) is provided to reduce risk resulting from becoming entangled in or tripping over
a longer cord. Extension cords (or longer detachable power-supply cord) are available and may
be used if care is exercised in their use.
• If an extension cord (or a long detachable power-supply cord) is used:
o The marked electrical rating of the detachable power-supply cord or extension
cord should be at least as great as the electrical rating of the appliance.
o If the appliance is of grounded type, the extension cord should be a grounding
type 3-wire cord; and the cord should be arranged so that it will not drape over the
countertop or tabletop where it can be tripped over, snagged, or pulled on
unintentionally (especially by children).
Reversing the Door Swing
Most of the blanket warmer’s doors can be hinged on either side, allowing the door swing to be
adjusted based on
the installation location. To reverse the position of the door hinges, follow
the steps below:
1. Lay the blanket warmer onto its backside, carefully set it on a blanket or a soft s
urface.
2. Remove the screws on the bottom hinge, remove it then set aside.
3. Slide the door downward, carefully remove the door pin attaching the door to the upper hinge.
4. Set the door aside.
5. Remove the screws holding the upper hinge to the unit.
6. Remove the hinge covers from the opposite side of the cabinet.
7. Move the upper hinge to the opposite of the cabinet and tighten with screws.
8. Replace the door pin on the opposite side of the door and slide the door pin into the upper
hinge.
9. Rest the door against the unit and attach the lower hinge to the cabinet and door.
10. If the door is not hanging straight, loosen the top hinge, adjust the door until it is properly aligned,
and then retighten the screws.
Note: The door reversal option is not available on all models.
Bekijk gratis de handleiding van Accucold AWC2PB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Accucold |
| Model | AWC2PB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1896 MB |
