Abus HUD-Y handleiding

25 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 4 van 25
5 6
3. Adjustement of the head ring
Almost all ABUS helmets are available in 2 sizes.
Adjusting the helmet to the individual head size
can be achieved, depending on the type, with the
following easy to use tting systems.
4. Adjustment of the straps
When wearing the helmet for the rst time, please adjust the straps so that they meet
tautly and comfortably beneath the ears.
The easily adjustable triangular locks on both sides, with their optional fastener (g. 1)
help you in doing so.
Make sure the chin-guard, which must be locked before every ride, doesn’t lie on the
jaw-bone (g. 2 – 5).
Aer adjustment, the overlapping straps can be secured with the strap clip (g. 6).
Should the straps be too long, please cut them down to the required length and seal the
ends with a match ame to prevent fraying.
5. Proper maintenance and care
Regularly check the helmet for signs of damage.
Do not alter the specication of this helmet as it will reduce its protective eect.
Do not apply stickers or paint to the helmet as this can be damaging to the materials.
Do not remodel or misuse the helmet.
Do not expose the helmet to temperatures in excess of 60˚C. Do not store behind glass,
e.g. in a car (burning glass eect), near heaters etc.
If you suspect that the helmet has received a large impact, even if there is no visible
damage, please purchase a new helmet.
This helmet has a limited service life and should be replaced when it shows obvious
signs of wear.
Depending on the frequency of use and the specic operational conditions, a bicycle
helmet must be replaced 4 - 5 years aer the rst time it is used. In view of the unavoi-
dable material fatigue, the helmet must, however, be replaced at most 8 years aer its
production date even if it displays no clear visible or technical defects
The helmet, inner pads and head ring can be cleaned using lukewarm water,
solvent-free detergents and a so cloth.
The LED rear light does not replace the statutory lighting installation requirement
for bicycles.
Only use original spare parts.
Battery instructions
This product contains a built-in 3,7 V lithium polymer battery (190mAh*2). Built-in
rechargeable batteries may only be replaced or removed by qualied personnel. Do not
charge or use the product in environments where there is a risk of explosion, e.g. from
ammable liquids, gases or dust. Never burn the product! The battery could explode in
the re. This would also release toxic substances.
Only use a suitable standard micro USB B charging cable in conjunction with a suitable
charger (5V DC power supply unit) for charging!
Do not leave the product unattended while it is charging!
Do not use or store the product in areas where the temperature could reach below 0°C or
above +60°C. Do not expose the product to direct sunlight for long periods of time.
Be careful when using magnets
ATTENTION: Magnets can damage credit cards or other cards
with magnetic strips. Magnets can also have an adverse eect
on pacemakers or other implanted devices. So ensure
sucient distance (approx. 20 cm) between the magnet
and the implanted devices – Danger to life!
Disposal
This product contains valuable raw materials. At the end of its service life, dispose of the
product in accordance with the applicable legal requirements.
Electrical appliances, rechargeable batteries and batteries must not be disposed of with
household waste. Disposal must be carried out in accordance with Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE), or Directive 2006/66/EC on batteries and
accumulators and waste batteries and accumulators.
Please contact the local authority responsible for disposal if you have any queries. You can
obtain information on collection points for your old appliances, for example, from the local
municipal or city administration, the local waste disposal companies, or your specialist
dealer.
Dispose of the packaging according to type. Separate the cardboard, foil and plastic ele-
ments for recycling.
WEEE-Reg.-Nr. DE79663011
ABUS_Helmets_HUD-Y_CE_BDA_148x105mm_MMO.indd 5-6ABUS_Helmets_HUD-Y_CE_BDA_148x105mm_MMO.indd 5-6 23.06.2022 09:23:3723.06.2022 09:23:37

Bekijk gratis de handleiding van Abus HUD-Y, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkAbus
ModelHUD-Y
CategorieNiet gecategoriseerd
TaalNederlands
Grootte5206 MB

Caratteristiche Prodotto

Kleur van het productGrijs
Gewicht330 g
GebruikershandleidingJa
LED backlightJa
GeslachtUnisex