Abac G-201 handleiding
Handleiding
Je bekijkt pagina 75 van 205
5.1 Disconnect the air supply from the tool
before lubricating it (1).
5.2 Add a few drops of tool oil to the air inlet.
Position the tool with the air inlet connector
facing upwards and place a drop of tool oil
inside the air inlet. Do not use cleaning oil or
additives. Put the tool into operation briey
after adding the oil (2).
Wipe off any excess oil in the outlet. Excess oil
may damage the O-ring seals of the tool. If a
lubrication system is used, manual lubrication
through the air inlet will not be necessary on a
daily basis.
EN
5. LUBRICATION
1
2
OIL
6.1 Disconnect the tool from the air tube.
Remove any spilled deposits with detergent #2.
Dry thoroughly before use (1).
6. CLEANING
WARNINGS: Disconnect the tool from the air
tube before cleaning and inspecting it.
Solve all problems before putting the tool
back into operation.
DANGER: Never use petrol or other
ammable liquids to clean the tool.
An fumes on the tool could ignite due
to a spark and cause the tool to explode,
resulting in serious personal injury or death.
NOTE: DO NOT IMMERSE the tool in cleaning
solvents as it could get damaged.
1
75
Bekijk gratis de handleiding van Abac G-201, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Abac |
| Model | G-201 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20820 MB |
