2N Telecommunications EasyGate handleiding
Handleiding
Je bekijkt pagina 64 van 69
Troubleshooting 6.3
64
6.3 Troubleshooting
For tips for the solution of other potential problems see faq.2n.cz.
No LED is on after power up
Check the power supply.
All LEDs are on. No call is currently in progress.
EasyGate is in the special PCManager-based programming mode - exit the
PCManager to reset EasyGate.
Try to switch EasyGate off and on, the LEDs should go off in 3s and signal
the status of EasyGate.
EasyGate does not register to GSM
Check the SIM card.
Check the PIN.
Check the antenna connection.
Select a place with a good GSM signal.
No tone can be heard after line off-hook
Check the telephone line connection.
EasyGate is not initialized properly upon start (approx. 10s after power
up).
EasyGate is not supplied with power.
EasyGate keeps transmitting a tone during dialing, not receiving the dialing
Select the correct dialing type (DTMF or pulse).
EasyGate does not communicate with PC
Check the serial cable connection.
Check the COM number setting on PC.
Check the COM parameters (1200-115200 bps, 8N1).
EasyGate is not registered to GSM network.
A dialing or outgoing call establishing process takes place on EasyGate.
An incoming call is ringing on EasyGate.
Bekijk gratis de handleiding van 2N Telecommunications EasyGate, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | 2N Telecommunications |
| Model | EasyGate |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6292 MB |
Caratteristiche Prodotto
| Markt positionering | Bedrijf |
| Ingangsspanning | 12 V |
| Soort apparaat | Gateway voor mobiele netwerken |
| Datanetwerk | GPRS, GSM |
| GSM bands ondersteund | 850,900,1800,1900 MHz |
