2N Telecommunications 932081E Handleiding (110 Pagina's)

Handleiding

2N TELEKOMUNIKACE a.s., www.2n.cz 41/110

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

If you use the brick flush mounting box, follow the instructions included in the box. If

you do not use the mounting box, follow the instructions below:

Make a hole using the template. Suppose that all the required cables have been

carried into the hole.

Unpack the frame, put the intercom inside and place the set onto the hole to

make sure that the hole is deep enough and the uneven edge is perfectly

covered with the frame.

Make sure that the dowel holes are drilled accurately! You will not be able to

align considerable inaccuracies with this way of mounting! Push or hammer the

enclosed dowels into the drilled holes. Use some suitable building adhesive if the

dowels are too loose.

Remove the front panel from the intercom.

Select the holes for cable supply. Insert the blanks into the other holes. Apply the

cable bushings or a suitable sealant to prevent penetration of insects or water.

You can also insert the small bushing in the intercom bottom hole.

Put the frame on the intercom.

Place the intercom into the hole while introducing the cables. Leave some of the

cables inside the unit as a reserve and the rest under the intercom bottom.

Insert the enclosed screws in the lateral mounting holes making sure they have

penetrated into the dowels. Tighten all the screws properly. Tip: The screw

tightening sequence may affect the intercom position.

We recommend to seal the frame – wall gap with a silicone or another sealant to

avoid wall dampening as a result of water leakage.

Do not complete mounting until you have finished electrical installation.

Bekijk gratis de handleiding van 2N Telecommunications 932081E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.